TestPad BTS-2002H - Pack Type and Voltage Configuration; Capacity, Charge, and Discharge Settings

Shenzhen TestPad Electronic Co., Ltd. http://www.test-pad.com
15
On the static parameter setup interface, there are 24 configurable items.
1. Pack type: The options include:
a) Lion: Li-ion battery
b) NiMH: Nickel-Metal hydride battery
c) NiCd: Nickel-Cadmium battery
d) SLA: Maintenance-free lead-acid battery
2. Pack Vol: The options include:
a)
For
Li-ion
battery,
it
may
increase
by
3.6V
per
additional
battery
,
and
the
maximum
value
is 14.4V (BTS-2004H).
b)
For
Nickel-Metal
hydride
battery
and
Nickel-Cadmium
battery,
it
may
increase
by
1.2V
per
additional battery, and the maximum value is 14.4V (BTS-2004H).
c)
For
the
SLA
battery,
it
may
increase
by
2V
per
additional
battery
,
and
the
maximum
value
is 12V (BTS-2004H).
3.
Pack
Cap:
Set
the
capacity
of
the
battery.
In
the
subsequent
test,
the
tester
will
automatically select the appropriate value for test according to the capacity set here. It may
increase by a step of 50mAH ~ 1000mAH per time, and the maximum value is 10000 mAH
(BTS-2004H).
4. Charge: Enable or disable the test. Press LEFT or RIGHT to adjust the selection.
5. Discharge: Enable or disable the test. Press LEFT or RIGHT to adjust the selection.
6.
Over
Current:
For
Li-ion
battery,
enable
or
disable
the
test.
For
other
battery
types,
this
function is unavailable.
7. R1: Enable or disable the test. (Identification resistor 1)
8. R2: Enable or disable the test. (Identification resistor 2)
9.
Vol-Min:
It
may
increase
or
decrease
by
a
step
of
10
mV.
When
the
battery
type
or
battery
voltage is changed, this parameter will be restored to the minimum default value.
10.
Vol-Max:
It
may
increase
or
decrease
by
a
step
of
10mV.
When
the
battery
type
or
battery
voltage is changed, this parameter will be restored to the maximum default value.
11. IMP-Min: The maximum value is 0.mΩ.
12.
IMP-Max:
The
maximum
value
is
999
m
Ω
.
If
it
is
set
to
be
a
value
larger
than
999
m
Ω
,
the
impedance test is disabled.
13.
OVC-Min:
This
parameter
can
be
adjusted
only
when
the
over-current
test
is
enabled.
It
may increase or decrease at a step of 0.1A.