EasyManua.ls Logo

Teuco 611 - Wintering Procedure

Teuco 611
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
31
611 - 612
GB
IN TEMPERATE CLIMATES
In areas where the temperature falls below zero only
occasionally, the water can be left in the minipool as
long as it has antifreeze protection.
CAUTION: leave the system connected to the electrical
power supply so that the antifreeze protection can
come into operation if the water should drop below
5 °C.
This function operates by activating the heater and the
whirlpool pumps in alternation until the water
temperature is raised to 7 °C.
IN COLD CLIMATES
Empty the minipool completely, as follows:
- isolate the minipool from the power supply (1)
- remove the inspection panel (2)
- open the drain valve and the bleed cocks (3)
- unscrew the drain plugs on the pump casings (4)
- using a liquids vacuum cleaner, remove water from
the bottom of the pool and from the AIR JET outlets.
Remove and clean the filters, and store in a dry place.
Cover the minipool with the canvas provided, so that it
will not collect dirt.
Before using the Teuco Minipool again after the winter
break, repeat the steps indicated for STARTING UP
FIRST TIME.
WINTERING PROCEDURE
1
3
4
2

Related product manuals