EasyManua.ls Logo

Teuco 611 - Setting the Water Temperature

Teuco 611
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
25
611 - 612
GB
INSTRUCTIONS
BLOWER
Press Blower to activate the Air jets function at HIGH
SPEED.
Press Blower a second time to select LOW SPEED.
Press Blower a third time to switch the air jets off.
QUICK START: the Blower can be activated by
pressing the remote button on the panel (I).
AROMATHERAPY
Teuco supplies essences for use in the minipool: these are
non-foaming substances that leave the water crystal clear
and will not harm the skin or deface the surfaces of the
tub.
The essence is put into the
DISPENSER (E), and always
with the Air Jet function off.
Unscrew the safety cap, put in the essence and close up
again.
Switch on the Air Jet function to mix the essence with the
water.
After 20 minutes continuous operation, the function
will switch off automatically.
37.0
°C
SETTING THE WATER TEMPERATURE
Use buttons
and
to select the desired
temperature of the water in the minipool.
The symbol ““ is displayed during the setting
procedure.
If the temperature of the water in the minipool is lower
than the setting, the heater will be activated.
The symbol ““ is displayed until the water has been
heated to the set temperature.
The temperature can be set between 15 °C and
40 °C
If other functions are activated when the heater is in
operation, the heater may be shut off automatically to
limit the power consumed by the minipool.
When the " " symbol blinks in the display, this
means that the heater is deactivated temporarily.
37.0
°C
37.0
°C

Related product manuals