Teuco 611 - Repairs; Diagnostics Messages; Removing Scuffs, Scratches and Cigarette Burns

The appliance is equipped with various safety features which monitor the operation of the system.
In the event of malfunction, the system responds automatically by deactivating the function currently
selected and displaying an error message.
32
611 - 612
GB
REPAIRS
DIAGNOSTICS MESSAGES
REMOVING SCUFFS, SCRATCHES AND CIGARETTE BURNS
Firstly, make certain that the scratch or burn
has affected only the surface of the acrylic
material.
This type of repair must be entrusted to a
professional with the necessary skills.
ACRYLIC
FIBREGLASS
If any part of the appliance fails to operate as it should (e.g. replacing the lamp in the light
fixture...), call the nearest Teuco Authorized Service Centre (see list attached).
CAUSE
Filters dirty or blocked.
Temperature of water in the minipool
too high.
Sudden loss of electrical power with
water heater in operation.
Pump valves closed or filter blocked.
Problem with temperature probe.
Water level too low.
ACTION
Clean the filters .
Set a lower temperature value and
wait for the water to cool.
If the fault persists, call the nearest
Teuco Authorized Service Centre.
Isolate the minipool from the power
supply and wait for the water to cool
down (about 1 hour). Power the
system up again, and
if the fault
persists, call the nearest Teuco
Authorized Service Centre.
Check that the pump valves are
open; clean the filters.
If the fault persists, call the nearest
Teuco Authorized Service Centre.
Call the nearest Teuco authorized
Service Centre.
Add water, and if the problem
persists, contact a
Teuco Authorized
Service Centre.
TROUBLE OR FAULT
CLE
HL Blinking
- The temperature of the water in the
minipool is higher than 44 °C.
HL permanently alight
- The temperature of the water in the
heater is higher than 48 °C.
FLO
- The system is not sensing any flow
of water in the recirculation circuit.
Prr
H2O