23
615
GB
INSTRUCTIONS
SETTING THE WATER TEMPERATURE
Use buttons “
V
” and “
W
” to select the desired temperature
of the water in the minipool.
The symbol “
“ is displayed during the setting procedure.
If the temperature of the water in the minipool is lower than
the setting, the heater will be activated.
The symbol “ “ is displayed until the water has been
heated to the set temperature.
The temperature can be set between 15 °C
and 40 °C
If the heater is in operation and other
functions are activated, the electrical input to
the heater can be reduced by the system to
limit the power consumption of the pool.
The blinking “
“ symbol indicates that the heater
is temporarily on low power.
37.0
°C
37.0
°C
ECONOMY
This function can be used to programme the
deactivation of the heater for a given period of time
(e.g. during the night).
Press the “Economy” button a first time to set the
duration of the Economy period (when the heater
remains off).
The display shows E OO.
Use buttons “
V
” and “
W
” to set the duration (from 0
to 24 hours).
Press “Economy” a second time to set the delay
before the Economy function cuts in (number of
hours between the time of programming and the time
the Economy period is due to start).
The display shows Ed OO.
Use buttons “
V
” and “
W
” to set the delay (from 0 to
23 hours).
Press the “Economy” a third time to terminate the
programming procedure.
E 00
E800
To Next Page
Loading...
