28
615
GB
The pool is equipped with systems allowing its use both
summer and in winter.
To prevent pipelines and components from freezing up in
cold weather, leave the system connected to the electrical
power supply so that the "antifreeze protection" can come
into operation if the water should drop below 5 °C.
This function operates by activating the heater and the
whirlpool pumps in alternation until the water temperature
is raised to 7 °C.
If the minipool is not going to be used in winter, it should
be emptied completely. Proceed as follows:
- isolate the minipool from the power supply (1)
- open the drain valve (2)
- remove the inspection panel (3)
- open the drain plug on the pumps (4)
- using a liquids vacuum cleaner, remove water from
the bottom of the pool and from the jet outlets
Remove and clean the filter, and store in a dry place
Cover the minipool with the canvas provided, so that it
will not collect dirt.
Before using the Teuco Minipool again after the winter
break, repeat the steps indicated for STARTING UP
FIRST TIME.
WINTERING PROCEDURE
1
3
2
4
To Next Page
Loading...
