Teuco 615 - Repairs; Diagnostics Messages; Removing Scuffs, Scratches and Cigarette Burns

29
615
GB
REPAIRS
The appliance is equipped with various safety features which monitor the operation of the
system.
In the event of malfunction, the system responds automatically by deactivating the function
currently selected and displaying an error message.
DIAGNOSTICS MESSAGES
REMOVING SCUFFS, SCRATCHES AND CIGARETTE BURNS
Firstly, make certain that the scratch or burn
has affected only the surface of the acrylic
material.
This type of repair must be entrusted to a pro-
fessional with the necessary skills.
ACRYLIC
FIBREGLASS
If any part of the appliance fails to operate as it should, call the nearest Teuco Authorized
Service Centre (see list attached).
CAUSE
Filters dirty or blocked.
Temperature of water in the
minipool too high.
Sudden loss of electrical power with
water heater in operation.
Pump valves closed or filter
blocked.
Problem with temperature probe.
Water level too low.
ACTION
Clean the filters .
Set a lower temperature value and
wait for the water to cool.
If the fault persists, call the nearest
Teuco Authorized Service Centre.
Isolate the minipool from the power
supply and wait for the water to cool
down (about 1 hour). Power the
system up again, and if the fault
persists, call the nearest Teuco
Authorized Service Centre.
Check that the pump valves are
open; clean the filters.
If the fault persists, call the nearest
Teuco Authorized Service Centre.
Call the nearest Teuco authorized
Service Centre.
Add water, and if the problem
persists, contact a Teuco
Authorized Service Centre.
TROUBLE OR FAULT
CLE
HL Blinking
- The temperature of the water in
the minipool is higher than 44 °C.
HL permanently alight
- The temperature of the water in
the heater is higher than 48 °C.
FLO
- The system is not sensing any
flow of water in the recirculation
circuit.
Prr
H2O