22 • CoreStation
Wireless Sub
To connect a wireless subwoofer to the CoreStation:
In the “System Setup” menu, select the submenu
“Wireless” and then the menu item “Wireless Sub”.
On the wireless subwoofer, start the process to estab-
lish a connection (see the corresponding operating
instructions).
Push the • button (23) twice to start the pairing
process. The function LED (19) will now quickly blink
in blue.
The connection will be established after a short time
and the status “Connected” is shown; you can now
use the wireless subwoofer with the CoreStation.
3.1/5.1
Here, you switch between 3.1 and 5.1 mode and
determine the function of the analogue output PRE
OUT (11) (see page 15), to which you can connect a
stereo amplifier, active speaker or wireless transmis-
sion system. This makes it possible to relay the audio
signal into another room or to connect to the surround
speakers in 5.1 mode via a wireless transmission
system (e.g. the Teufel RearStation 4).
3.1 Convert (downmix) the 5.1 audio signal to the
two stereo channels (2.0) to relay the audio
signal into a second room.
5.1 Output of the surround channels.
D/E
Here you can set the screen menu language this way.
Possible values: Deutsch, English
System Reset
This resets the device to the factory default.
To Next Page
Loading...
