Texas Instruments BA Real Estate - Percent Change and Appreciation Model

Other Financial Tools 69
BEAR-CH3.DOC BA Real Estate Guidebook Bob Fedorisko Revised: 08/29/96 9:19 AM Printed: 09/28/99 1:21 PM
Page 69 of 20
Key Sequence Function
# 7
Enters the starting value.
# 8
Enters the ending value.
# 9
Enters the number of compounding
periods during the change from V1 to
V2.
# :
Enters the percent change from V1 to
V2 (when #PD=1), or the rate of appre-
ciation per period (when #PD > 1).
Note: #PD is automatically set to a value of 1 when you
first activate this model.
To calculate the total rate of change or appreciation, #PD
must be set to 1.
When #PD is set to a value other than 1, the calculated rate
of change or appreciation is the periodic rate.
Percent Change and Appreciation Model
A single model calculates both percent change and rate
of appreciation (compound growth). You can enter any
three of the model's values and compute the fourth.
Values Used by
the Model
A Note about
Number of
Periods