1 Board Overview
1.1 Kit Contents
The F28003x Series LaunchPad Development Kit contains these items:
• C2000 F28003x Series LaunchPad development board (LAUNCHXL-F280039C)
• USB Type-A male to USB Type-C™ male cable
• Pinout Map
1.2 Features
The F28003x LaunchPad has these features:
• C2000 Series F280039CPNS (100-pin) microcontroller:
– With Configurable Logic Block (CLB) capability
• On-board XDS110 debug probe
• Two user-controlled LEDs
• One microcontroller reset switch
• Selectable power domains:
– USB (isolated)
– BoosterPack
– External power supply
• CAN connector with on-board CAN transceiver
– Supports both standard CAN (DCAN) and CAN-FD (MCAN)
• Two independent Enhanced Quadrature Encoder Pulse (QEP)-based encoder connectors
• FSI peripheral connector
• Two independent BoosterPack XL standard connectors (80-pins) featuring stackable headers to maximize
expansion through the BoosterPack ecosystem
1.3 Specifications
Table 1-1 summarizes the F28003x LaunchPad specifications.
Table 1-1. LAUNCHXL-F280039C Specifications
Parameter Value
Board Supply Voltage
5 V
DC
from one of the following sources:
• USB Connector (USB101) - USB Type-C™ cable connected to PC or other compatible
power source.
• BoosterPack 1
• BoosterPack 2
• Auxiliary power connectors
Dimensions 5.5 in x 2.3 in x .425 in (13.97 cm x 5.84 cm x 10.8 mm) (L x W x H)
Break-out Power Output
• 3.3 V
DC
to BoosterPacks, limited by output of TPS7A3701 LDO. This 3.3-V plane is
shared with on-board components. Total output power limit of TPS7A3701 is 1 Amp.
Assumed Operating Conditions
This kit is assumed to run at standard room conditions. The EVM should run at
approximately standard ambient temperature and pressure (SATP) with moderate-to-low
humidity.
www.ti.com Board Overview
SPRUJ31 – APRIL 2022
Submit Document Feedback
C2000
™
F28003x Series LaunchPad
™
Development Kit 3
Copyright © 2022 Texas Instruments Incorporated
To Next Page
Loading...
Need help?
General
