Texas Instruments TI-Nspire CX II-T User Manual

8 Getting Started with TI-Nspire™ CX II Handhelds
Icon Function
¡ ¢
Page scrolling arrows - Use the touchpad to click these arrows and scroll
through the pages in a document.
Page tab - Labels the problem number and page number of the active page.
For example, a label of 1.2 identifies Problem1, Page2. If problems are
named, hover the pointer over a tab to view the page name.
*Doc Document name - Shows the current document name. An asterisk by the
document name indicates changes were made since the document was last
saved. Click the name to open the Documents menu.
Press to Test - Indicates that the handheld is in Press-to-Test mode.
Login status - Shows whether the handheld is searching for an access point
(blinking), found an access point (solid), not communicating, connected and
ready to log in (a blinking arrow) or logged in and charged (a solid arrow). Click
here to view Settings & Status.
CAPS
Shows status of the g, /, andÊ keys.
RAD Angle Mode - Shows an abbreviation of the angle mode (Degrees, Radians or
Gradians) in effect. Hover the pointer over the indicator to see the full name.
Note: Click the indicator to toggle between RAD and DEG modes.
Settings & Status - Shows an indicator of the current charge level of the
battery. Hover the pointer over the indicator to read the status as a
percentage. Click the icon to open the Settings & Status menu.
Close document - Click the icon to close the current document. If information
is unsaved, save or discard when prompted.

Texas Instruments TI-Nspire CX II-T Specifications

General

Brand	Texas Instruments
Model	TI-Nspire CX II-T
Category	Calculator
Language	English