54 Working in a TI-Nspire™ CX Premium Teacher Software Classroom
Working in a TI-Nspire™ CX Premium Teacher Software
Classroom
If you are in a classroom where TI-Nspire™ CX Premium Teacher Software is used, you
will need to log in to class to communicate with the teacher’s computer. The teacher
can communicate with your handheld in the following ways:
• Send files
• Collect files
• Delete files
• Send Quick Polls and receive Quick Poll responses
The teacher can also pause and restart your handheld. When class is paused, you will
receive a message on your handheld. You cannot use your handheld until the teacher
releases the handheld from pause mode.
Using Wireless Communication Hardware
Teachers using TI-Nspire™ CX Premium Teacher Software in the classroom can attach
wireless cradles and/or network adapters to students' TI-Nspire™ CX handhelds. Those
handhelds can then link wirelessly to an access point attached to the teacher's
computer.
You can attach any the following devices to TI-Nspire™CX handhelds:
• TI-Nspire™ CX Wireless Network Adapter - v2 (2.4 GHz or 5.0 GHz band)
• TI-Nspire™ Wireless Network Adapter (2.4 GHz)
Attaching a Wireless Adapter to a CX Handheld
Note: The battery in the handheld powers the wireless adapter.
1. Position the wireless adapter on top of the handheld so the connector on the
adapter lines up with the connector on top of the handheld.
Wireless network adapter (school-owned)
Connector
Guides for aligning
with handheld
2. Slide the adapter into position, making sure the guides on the sides of the adapter
slide into the grooves on the sides of the handheld.
To Next Page
Loading...
Need help?
General
