Texas Instruments TI-Nspire CX II-T User Manual

90 Updating the Handheld Operating System
Shown
on:
Message and Description
This message is displayed when an OS Upgrade is about to begin. If you do not
select Yes within 30 seconds, the system automatically responds with No.
Receiving
handheld
“Receiving OS. Do not unplug cable.“
This message, along with a progress bar, is displayed while the OS Upgrade is
being transferred.
Receiving
handheld
“Installing OS.“
This message is displayed when the transfer is complete. It is shown to keep
you informed of the handheld’s status.
Receiving
handheld
“OS has been installed. Handheld will restart.“
OK
This information message displays briefly before the handheld automatically
reboots.
Receiving
handheld
“Install was corrupted. Handheld will reboot. You will need
to retry OS upgrade.“
OK
An error occurred during the transmission and the installation was corrupted.
The handheld will reboot. After the reboot, reinstall the OS Upgrade.

Texas Instruments TI-Nspire CX II-T Specifications

General

Battery	Rechargeable Lithium-ion
Operating System	TI-Nspire OS
Programming	TI-Basic, Lua
Type	Graphing Calculator
RAM	64 MB
ROM	128 MB
Model	TI-Nspire CX II-T
Display	320 x 240 pixels
Connectivity	USB
Processor	ARM9
Certification	SAT, ACT, AP, IB, PSAT/NMSQT
Memory	64 MB RAM
Weight	269 g