CHAPTER 7. USING THE TABLE
7.2 The Table Settings
Press to enter the TBLSET screen.
There are four potential settings that you can adjust. The bottom setting, Independent, is the most
important.
Independent: Auto or Ask
If this is set to Auto , your table will be automatically generated using the other three settings.
If this is set to Ask , you will need to enter in each x-value one at a time for the table to have any
information.
If you’re using Auto, you will need to adjust the following settings:
tblStart
This value will be the first x-value used in your table.
∆tbl
This value is the distance between each x-value in the table.
Graph <−> Table
There are two options, either ON or OFF.
You will typically want this option to be set to OFF.
Make sure you press twice to save any changes you’ve made. When you do this, you’ll
be taken back to the window you previously were using.
Example:
Set the TBLSET settings to the following:
tblStart: −2
∆tbl: 1
Graph: OFF
Independent: AUTO
Press
twice to make sure the changes are saved. You will be taken back to the Y= screen.
38
To Next Page
Loading...
Need help?
General
