Texas Instruments Tiva TM4C123GH6PM User Manual

GPIO
Prototype:
void
ROM_GPIOPinTypeI2C(uint32_t ui32Port,
uint8_t ui8Pins)
ROM Location:
ROM_APITABLE is an array of pointers located at 0x0100.0010.
ROM_GPIOTABLE is an array of pointers located at ROM_APITABLE[4].
ROM_GPIOPinTypeI2C is a function pointer located at ROM_GPIOTABLE[16].
Parameters:
ui32Port is the base address of the GPIO port.
ui8Pins is the bit-packed representation of the pin(s).
Description:
The I2C pins must be properly configured for the I2C peripheral to function correctly. This
function provides the proper configuration for those pin(s).
The pin(s) are specified using a bit-packed byte, where each bit that is set identifies the pin to
be accessed, and where bit 0 of the byte represents GPIO port pin 0, bit 1 represents GPIO
port pin 1, and so on.
Note:
This cannot be used to turn any pin into an I2C pin; it only configures an I2C pin for proper
operation.
Returns:
None.
10.2.1.20 ROM_GPIOPinTypeI2CSCL
Configures pin(s) for use as SCL by the I2C peripheral.
Prototype:
void
ROM_GPIOPinTypeI2CSCL(uint32_t ui32Port,
uint8_t ui8Pins)
ROM Location:
ROM_APITABLE is an array of pointers located at 0x0100.0010.
ROM_GPIOTABLE is an array of pointers located at ROM_APITABLE[4].
ROM_GPIOPinTypeI2CSCL is a function pointer located at ROM_GPIOTABLE[39].
Parameters:
ui32Port is the base address of the GPIO port.
ui8Pins is the bit-packed representation of the pin(s).
Description:
The I2C pins must be properly configured for the I2C peripheral to function correctly. This
function provides the proper configuration for the SCL pin(s).
The pin(s) are specified using a bit-packed byte, where each bit that is set identifies the pin to
be accessed, and where bit 0 of the byte represents GPIO port pin 0, bit 1 represents GPIO
port pin 1, and so on.
100 April 8, 2013

Texas Instruments Tiva TM4C123GH6PM Specifications

General

Brand	Texas Instruments
Model	Tiva TM4C123GH6PM
Category	Microcontrollers
Language	English