Texas Microsystems, Inc. 2003 - Page 14

27. Floppy disk drives are tested. If an error occurs
one o£ the £ollowing messages is displayed:
Floppy seek error • •
Press F1 to Continue.
Floppy reset error • •
Press F1 to Continue.
If a floppy disk error occurs, the Setup
Utility is invoked automatically. The
floppy disk drive configuration data on
the Setup screen should be checked. If
the con£iguration is accurate, re£er to
Section 3 on Troubleshooting.
28. Printer and RS232 timeouts are set
29. The type £loppy disk drive is determined.
30. Base addresses for RS232 cards are determined.
31. Base addresses for the printer card are deter-
mined.
32. BIOS tests for the existenee of the 80287 numeric
coprocessor.
33. Memory test is performed on the video card. If an
error occurs, the following message is displayed:
Memory Test Failure
Address = xxxx, Data = yyyy
Continue? (YIN)
Where:
x = address
y = failing bit pattern
!'!2!:!
If Y is entered to continue the BIOS
will try to down-size the memory and
continue the power-up sequence. If an
error exists, it is recommended that the
user rectify the problem, since un-
reliable operation may occur otherwise.
34. The monitor
displayed.
screen is cleared and the TMI logo is
The £ollowing message is displayed:
The TMI INDUSTRIAL COMPUTER BIOS
Self-Test in Progress, Please Wait
Preliminary AT Users Manual
11 11/26/86