Texecom Premier 24 - Keypad Lock

Overview Premier Series User Guide
2 INS221
1. Overview
Introduction
Users of the alarm system will be assigned a unique 4, 5 or 6 digit User code. User
codes are used to arm and disarm the system. Some User codes can also access
additional options such as, system tests and omitting zones.
Keypads will be installed throughout the premises, usually one at each entry/exit door.
The keypads are used to perform all of the system operations i.e. Arming, Disarming etc.
Most User codes can be used at any keypad on the system. However, Local Users will only
be able to use certain keypads on the system.
The Emergency Keys
In case of emergency, the alarm system can provide three immediate emergency alarms
by pressing and holding two specific keys for two seconds.
!"
The emergency keys can be enabled/disabled for each keypad on the system.
The Panic alarm can be programmed for either audible or silent operation.
The Panic alarm can be programmed for either instant or delayed operation.
Emergency Alarm Press Keys
Panic Alarm (PA)
!
&
"
Fire
#
&
$
Medical
%
&
&
The Quick Arm Keys
The ‘Quick Arm’ keys allow the system to be armed without having to enter a User code first.
!"
The ‘Quick Arm’ keys will only work if the keypad has been programmed to allow
arming in this way.
To FULL arm the system, press
'
.
To PART arm the system, press
!
,
(
or
"
followed by
)
.
Keypad Lock
The keys on the keypad can be locked to prevent unwanted access to the system.
!"
The Emergency keys will NOT operate with the keys locked.
To Lock the keys, press
*
and
+
together.
To Unlock the keys, press
*
and
+
together again.