Premier Series User Guide Operating the Alarm System
INS221 7
To RESET After an Alarm
USER Reset
Once the alarm has been silenced (see page 6 for details), the system will need to be reset.
!"
If the system has been programmed, to be reset by an Engineer, pressing
1
will
not return the display to normal, if this is the case see ENGINEER Reset for details.
The system may have been programmed to be reset by Anti-code, if this is the
case, see ANTI-CODE Reset for details.
1. Enter a valid User code
,,,,
2. Press
1
The external strobe will stop, the system will chime and the display will return to normal.
ENGINEER Reset
If the system has been programmed to be reset by an Engineer following an alarm
activation, you will still be able to silence the alarm by entering a valid User code (see
page 6 for details).
!"
The system cannot be armed again until the alarm has been reset.
1. Contact the telephone number on the display (if programmed) or the telephone
number on the last page of this User Guide
ANTI-CODE Reset
If the system has been programmed to be reset using an Anti-Code following an alarm
activation, you will still be able to silence the alarm by entering a valid User code (see
page 6 for details).
!"
The system cannot be armed again until the alarm has been reset.
1. Enter a valid User code
,,,,
2. Press
1
The display will show a random code number i.e. 4281.
3. Contact the telephone number on the display (if programmed) or the telephone
number on the last page of this User Guide and quote the random code number
You will be given a 4-digit Anti-Code i.e. 5624.
4. Enter the Anti-code that has been given to you
,,,,
5. Press
*
If the Anti-code is correct, the keypad will bleep to indicate that the system has been
reset and the display will return to normal.
To Next Page
Loading...
Need help?
General
