Operating the Alarm System Premier Series User Guide
6 INS221
To DISARM the System When Not in Entry
1. Enter a valid User code
,,,,
2. Press
*
To CANCEL the Exit Mode
Once the exit mode has been started you should leave the premises immediately,
however, if for some reason you decide not to leave, the exit mode must be cancelled.
1. Enter a valid User code
,,,,
2. Press
*
The exit tone will stop.
To CLEAR an Arm Fail
When the system tries to arm with zones active (open), the internal sounders will sound
and the external strobe will be flashing to indicate a problem. For details on preventing
an Arm Fail condition, please refer to page 3.
!"
If you were not present when the Arm Fail occurred or you do not clear the Arm
Fail, the internal sounders will continue to sound and the external strobe will
continue to flash.
1. Enter a valid User code
,,,,
The internal and external sounders will stop, the external strobe will continue to flash
and the number of the zone that caused the Arm Fail will be displayed.
2. Enter a valid User code
,,,,
and press
12
To SILENCE an Alarm
When an alarm occurs on the system, the internal and external sounders will normally
sound for a pre-programmed time (normally 15 minutes).
!"
If you were not present when the alarm activated, the internal and external
sounders may have already stopped but the external strobe will still be flashing.
When alarm information is being displayed, pressing the SCROLL key will slow
down the display and also allow manual scrolling through the events.
1. Enter a valid User code
,,,,
The internal and external sounders will stop and the number of the zone that caused the
alarm will be displayed.
The alarm now needs to be reset.
To Next Page
Loading...
Need help?
General
