EN
6
TEXI Compacta
4. Lubrication
Lubrication is important because it ensures trouble-free operation and long machine life. Therefore, after setting the machine,
as described in Chapter 3 A, it’s necessary to let a few drops of oil to all openings of the machine, as shown on Figure 7.
After opening the side cover and back cover one should also lubricate moving parts inside the machine.
Every day, before work, you should let one or two drops of oil to all openings indicated on Figure 7.
It is recommended that lubrication was carried out always after work, in order to avoid contamination of sewn material. Thus,
excessive oil can trickle, and in the machine will remain only the required amount of it. Prior to starting work, verify that the
machine was cleaned from excessive oil. To completely remove the excessive oil, before starting work you should stitch for
about a minute on the machine, with the knee lift pressed.
5. Needle and material
It is recommended to use needles system 2140 TP (LWx6T).
In order to obtain best sewing result, you should properly adjust needles size to the sewn material.
NEEDLE (size) MATERIAL
80
Silk and other delicate materials
90
Cotton, wool and other middle weight materials
100
Thick cotton and other trick materials
To Next Page
Loading...
Need help?
General
