Checking direction of rotation of Single Phase Openwell Submersible Monoblock
Danger
Hazardous voltage will cause death, serious injury, electrocution.
All electrical work must be performed by an authorised electrician, in
compliance with local electrical equipment standards and internal
wiring codes.
Connect the Single Phase Openwell Submersible to the control panel, power up the Openwell
Submersible, and observe if the direction of rotation of the impeller matches the arrow mark on
the volute casing / suction chamber
In case the direction does not match the arrow mark, please take the product to the dealer from
whom the purchase was made for rectification
Electrical Installation
Check the power supply voltage and frequency and compare with the product requirements
specified on the nameplate
Observe relevant EB regulations while giving power supply to the motor
As far as possible, do not use multiple joints in the electrical cabling while connecting the
Control Panel to the Single Phase Openwell Submersible
Ground the Single Phase Openwell Submersible using the two earth screws provided on the base
plate of SSM and single earth screw provided on the motor body of SVSM
Ensure electrical joints, if any, are properly and adequately insulated
Connect the cable properly to the starter terminals to avoid loose connections
Factor in low-voltage operation while selecting cable size
OMOW002A 21 2020.01
To Next Page
Loading...
Need help?
General
