41
Hand Brake Lever/Brake
Lever Lock
CF301A
The hand brake is considered to be the
normal operating (main) brake. It should
be applied whenever a braking situation
is needed.
Apply the brake by compressing the
brake lever toward the handlebar.
To engage and release the brake lever
lock, use the following procedure.
1. Squeeze the hand brake two or three
times and release it.
2. Depress and hold the brake lever
lock.
3. While holding in on the brake lever
lock, squeeze the brake lever.
NOTE: It will click as it engages
and the brake lever will not return to
its released position.
4. Attempt to push the ATV. Check to
make sure the brake lever lock
engages properly and that the brake
(when engaged) locks the wheels.
NOTE: The brake lever lock must
lock the wheels. If it doesn’t, take the
vehicle to an authorized dealer for
service.
5. Release the brake lever lock by
squeezing the brake lever. It will
return to its released position.
Headlight HI/LO Switch
CF245A
Use the headlight HI/LO switch to select
the high or low headlight beam when the
ignition switch is in the LIGHTS position.
When the switch is in the HI position, the
high beam will illuminate. When the
switch is in the LO position, the low beam
will illuminate.
Emergency Stop Switch
OFF position — The ignition circuit is off.
The engine cannot be started or will not
run. If the emergency stop switch is used
to stop engine without turning off ignition
switch, the battery may discharge.
RUN position — The ignition circuit is
on. The engine can start and run.
In an emergency, slide the switch to the
OFF position to stop the engine. Apply
the brakes to stop the wheels.
! WARNING
The 4WD lock is intended for use
where minimum traction is available.
NEVER EXCEED 10 MPH (16 kph)
with
the lock engaged. Maneuverability
and handling characteristics will dif-
fer with the lock engaged.
! WARNING
Always check to be sure that the brake
lever lock has been disengaged before
operating the ATV. An accident could
result if the brake lever lock is left
engaged while the ATV is operated.
The brake may relax if left engaged for
a long period of time. This could
cause an accident; therefore, do not
leave the ATV on a hill depending on
the brake lever lock. Always block the
downhill side of the wheels if leaving
the ATV on a hill or park the ATV in a
sidehill position.
To Next Page
Loading...
