59
10. Remove the jumper cables in oppo-
site order of hook-up (4, 3, 2, 1). Be
careful not to short cables against
bare metal.
NOTE: Have the battery and elec-
trical system checked prior to oper-
ating the vehicle again.
Spark Plug
The ATV comes equipped with a specified
spark plug. See the specifications chart for
the correct spark plug. To help prevent
cold weather fouling, make sure to thor-
oughly warm up the engine before operat-
ing.
Before removing the spark plug, be sure
to clean the area around the spark plug. If
you do not, dirt could enter engine when
removing or installing the spark plug.
To maintain a hot, strong spark, keep the
plug free of carbon.
ATV-0051
A light brown insulator indicates that the
plug is correct. A white or dark-colored
insulator indicates that the engine may
need to be serviced. Consult an authorized
dealer if the plug insulator is not a light
brown color.
Adjust the gap to specified
amount (see specifications chart) for
proper ignition. Use a feeler gauge to
check the gap.
ATV0052B
A new spark plug should be tightened 1/2
turn once the washer contacts the cylin-
der head. A used spark plug should be
tightened 1/8 - 1/4 turn once the washer
contacts the cylinder head.
Throttle Cable Adjustment
To adjust the throttle cable free-play:
1. Loosen the jam nut from the throttle
cable adjuster.
2. Slide the rubber boot away and turn the
adjuster until the throttle lever has
proper free-play of 3-6 mm (1/8-1/4 in.).
CF297A
3. Tighten the jam nut against the
throttle cable adjuster securely; then
slide the rubber boot over the
adjuster.
Air Filter
The air filter inside the air filter housing
must be kept clean to provide good engine
power and gas mileage. If the ATV is used
under normal conditions, service the filter
at the intervals specified in the Mainte-
nance Schedule. If operated in dusty, wet,
or muddy conditions, inspect and service
the filter more frequently. Use the follow-
ing procedure to remove the filter and
inspect and/or clean it.
1. Remove the fasteners securing the
storage compartment and remove
the storage compartment.
2. Remove the air filter housing cover
and the air filter/frame assembly.
CAUTION
Failure to inspect the air filter fre-
quently if the ATV is used in dusty,
wet, or muddy conditions can dam-
age the engine.
To Next Page
Loading...
