Textron ALTERRA TBX 700 EPS 2018 - Tailgate Latch (TBX); Cargo Box Latch Handles (TBX); Side Storage Compartment (TBX); Safety Flag Bracket

46
2. To lock the seat into position, slide
the front of the seat into the seat
retainers and push down firmly on
the rear of seat. The seat should
automatically lock into position.
Tailgate Latch (TBX)
739-569A
1. To open the tailgate, pull the latch
(located at the center of the tailgate).
2. To close the tailgate, press forward
firmly. The tailgate will latch auto-
matically.
Cargo Box Latch Handles
(TBX)
739-569B
1. To raise the cargo box, rotate either
handle upward; then raise the cargo
box.
2. To lower the cargo box, push down
firmly on the front of the box. The box
will automatically lock into position.
Side Storage
Compartment (TBX)
TB013
1. To open a compartment, lift the
straps off the hatch lugs.
2. To close a compartment, pull the
straps over the hatch lugs.
Safety Flag Bracket
A bracket is provided for mounting a flag
at the rear of the ATV.
Rack Loading (Front and
Rear)
The front rack and rear rack are designed
to carry specified load capacities. Always
refer to the ATV Load Capacity Ratings
chart for proper capacities.
Trailering and Towing
This vehicle is equipped with a frame-
mounted receiver for a standard 5.1 cm
(2 in.) receiver hitch. The standard
receiver hitch must be purchased sepa-
rately.
! WARNING
Make sure the seat is secure before
mounting the ATV. Severe personal
injury may result if the seat is not
properly secured.
! WARNING
Make sure the loads on the front and
rear racks will not interfere with the
ATV controls or obstruct the view of
the operator. Also, make sure the
loads are evenly distributed, properly
secured, and will not shift while oper-
ating the ATV.
! WARNING
Never use the racks as a towing or
trailering point.