42
Starter Button
Pushing in on this button activates the
starter motor. Before starting the engine,
make sure the ignition switch is in the
ON position, the transmission is in neu-
tral, and the brake lever lock is engaged.
NOTE: This ATV has safety interlock
switches which prevent the starter
motor from activating when the trans-
mission is not in neutral. To start the
ATV while in gear, depress the rear foot
brake or compress the brake lever;
then depress the starter button.
Reverse Override Switch
This ATV is equipped with a reverse
speed limiter system. When additional
RPM is needed in reverse, depress and
hold the override switch.
NOTE: The reverse override switch
is active in 4WD only.
Throttle Lever
FI475B
Control engine RPM with the position of
the throttle lever. Operate this lever with
the thumb. Pushing it forward increases
engine RPM and allowing it to retract
decreases engine RPM.
Throttle Limiter Screw
XR233A
Throttle lever travel may be limited by
adjusting the throttle limiter screw. The throt-
tle limiter should be adjusted according to the
operator’s skill and experience. To adjust the
throttle limiter, use the following procedure.
1. Loosen the jam nut.
2. Turn the throttle limiter screw clock-
wise to decrease engine RPM maxi-
mum or counterclockwise to
increase engine RPM maximum.
3. Tighten the jam nut securely.
NOTE: The ATV is equipped with
an RPM limiter that retards ignition
timing when maximum RPM is
approached. When the RPM limiter is
activated, it could be misinterpreted
as a high-speed misfire.
Rear Foot Brake
TXA002A
Pressing the rear foot brake downward
will apply the brake to the rear wheels.
Power Steering
Certain models were produced with an
Electronic Power Steering (EPS) system
to reduce steering effort and driver
fatigue over a broad range of operating
conditions.
! WARNING
Never activate the override switch
while the throttle is open as a loss of
control may result. Use caution when
using the override switch as reverse
speed can greatly increase.
To Next Page
Loading...
