60
3. Remove the foam element from the
frame making sure not to tear the
element.
FI705
4. Place the element in a pan larger
than the element and spray both
sides generously with cleaning sol-
vent. Let sit approximately three
minutes.
NOTE: Foam Air Filter Cleaner and
Foam Air Filter Oil Aerosol are avail-
able.
5. In a pan larger than the element,
with a mild detergent (dish soap)
and water, wash all the dirt and oil
off by squeezing the element not
twisting it. (Wringing out or twisting
the filter can cause damage.)
6. Rinse off any remaining soap.
7. Remove any excess water from the
element by pressing it with a towel.
8. Allow the element to dry com-
pletely.
9. Spray oil generously onto air filter
and work the oil into the element.
10. Squeeze the element to remove
excess oil.
11. Clean any dirt or debris from inside
the air cleaner.
12. Install the air filter/frame assembly
and cover.
13. Install the storage compartment and
cover.
Air Filter Housing Drain(s)
Inspect the drain(s) beneath the main
housing for debris and for proper sealing.
TXA024A
Draining V-Belt Cover
NOTE: If the ATV has been driven
through water, the V-belt cover must
be drained of any water.
1. Place the ATV on a level surface.
2. Remove the drain bolt from the
cover and allow the water to drain
out.
CF110A
3. Shift the range lever to the neutral
position; then start the engine.
4. Increase and decrease engine RPM
several times to “blow out” any
water; then stop the engine.
5. Install the drain bolt and tighten
securely.
NOTE: The V-belt and pulleys
should be inspected every 500 miles
and the belt replaced (if necessary).
CAUTION
A torn air filter can cause damage to
the ATV engine. Dirt and dust may get
inside the engine if the element is torn.
Carefully examine the element for tears
before and after cleaning it. Replace
the element with a new one if it is torn.
To Next Page
Loading...
