57
2. Be sure the charger and battery are
in a well-ventilated area. Be sure the
charger is unplugged from the 110-
volt electrical outlet.
3. Connect the red terminal lead from
the charger to the positive terminal
of the battery; then connect the black
terminal lead of the charger to the
negative terminal of the battery.
NOTE: Optional battery charging
adapters are available from your
authorized dealer to connect directly
to your vehicle from the recom-
mended chargers to simplify the
maintenance charging process.
Check with your authorized dealer
for proper installation of these
charging adapter connectors.
4. Plug the battery charger into a 110-
volt electrical outlet.
5. If using the CTEK Multi US 800,
there are no further buttons to push.
If using the CTEK Multi US 3300,
press the Mode button (A) at the left
of the charger until the Maintenance
Charge Icon (B) or Normal Charge
Icon (E) at the bottom illuminates.
The Normal Charge Indicator (C)
should illuminate on the upper por-
tion of the battery charger.
3300C
NOTE:
For optimal charge and per-
formance, leave the charger con-
nected to the battery for a minimum 1
hour after the Maintenance Charge
Indicator (D) illuminates.
The main-
tainer/charger will charge the battery
to 95% capacity at which time the
Maintenance Charge Indicator (D)
will illuminate and the maintainer/
charger will change to pulse/float
maintenance. If the battery falls
below 12.9 DC volts, the charger will
automatically start again at the first
step of the charge sequence.
If the
battery becomes hot to the touch, stop
charging. Resume after it has cooled.
NOTE: Not using a battery charger
with the proper float maintenance
will damage the battery if connected
over extended periods.
6. Once the battery has reached full
charge, unplug the charger from the
110-volt electrical outlet.
NOTE: If, after charging, the bat-
tery does not perform to operator
expectations, bring the battery to an
authorized dealer for further trouble-
shooting.
Jump-Starting
NOTE: Jump-starting a vehicle
with a dead battery is not recom-
mended but rather removing the bat-
tery, servicing it, and correctly
charging it; however, in an emer-
gency, it may be necessary to jump-
start a vehicle. If so, use the follow-
ing procedure to carefully and safely
complete this procedure.
! WARNING
Improper handling or connecting of a
battery may result in severe injury
including acid burns, electrical burns, or
blindness as a result of an explosion.
Always remove rings and watches.
To Next Page
Loading...
