18
BZT 2000
Series
ADJUSTMENTS
Parking brake assembly (fuel tank, tire and deck
not shown for clarity - brake in ON position).
PARKING BRAKE
Start with parking brake N in the OFF position.
1. Adjust the parking brake rod to provide a distance
of 14-3/16” between pin K and pin L
2. Disconnect one end of rods M (at brakes on both
sides of the machine).
3. Move the parking brake lever to the ON position.
4. Adjust rods M on each brake to be 3/4” short of
connecting to the spring when all the slack is
taken out of the brake linkage and brake lever N.
5. Move the parking brake to the OFF position and
reconnect rods M.
This adjustment will cause the brake springs to
stretch 3/4” when the brake is in the ON position to
provide the correct parking brake force without
overloading the brake.
DECK LEVELING
NOTE: These instructions are in regards to both
sides of the deck.
To level deck:
1. Park the machine on a smooth, level surface.
Remove the height of cut pin A and raise the
cutterdeck to the 3" height of cut position.
2. Locate (2) 3" tall blocks just inside the front rollers
and (2) 2-7/8" tall blocks just inside the rear
rollers.
3. Lower the deck until it is resting on the blocks and
there is plenty of float for the actuator B.
4. Loosen the jamnuts on the height of cut clips.
Adjust the thread rolling screws C on the front
and rear chains until the chains just become tight.
Tighten the jamnuts against the clips.
To Next Page
Loading...
