Textron EZGO User Manual

OPERATION AND SERVICE INFORMATION
Page 3
Owner’s Manual and Service Guide
Read all of Manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
HORN
The horn is operated by pushing the horn button located
on the floor to the left of the brake pedal (Ref Fig. 5 on
page 2)
PLASTIC LOAD BED
The manual lift bed is the standard bed for the vehicle.
The bed may be equipped with an optional electric lift
switch.
Failure to follow
these instructions
may result in per-
sonal injury, damage the vehicle and/or
cause the vehicle to tip over. Operate the
vehicle with awareness of the load. Read,
understand and follow the Danger label
affixed to the front of the load bed.
Do not permit anyone to ride in the bed.
Before operating, check to ensure no one is
behind the vehicle.
A load bed warning label is affixed to the inside front of
the bed (see Appendix A). This label must be understood
and observed at all times for safe operation of the vehi-
cle. See the load bed warning label for maximum load.
The load must be positioned in the bed as far forward as
possible, distributed in such a way that its center of grav-
ity must not be higher than height noted on label, and
securely fastened down. Failure to follow these instruc-
tions may result in severe personal injury, damage the
vehicle and/or cause the vehicle to tip over. Operate the
vehicle with awareness of the load.
Do not permit anyone to ride in the bed.
Do not drive the vehicle with the load bed raised or with
the tailgate unsupported.
Never fill a gas can
in the bed of a vehi-
cle. Static dis-
charge could ignite gasoline vapor and
cause an explosion.
Always place a gas can on the ground before filling.
Never fill a gas can in the bed of the vehicle. Static elec-
tricity is built up during the fueling process and could dis-
charge causing the gasoline vapor to ignite.
MANUAL LIFT BED OPERATION
Exercise caution
while operating the
manual lift bed to
ensure the bed is not released during lifting
or lowering procedure. Severe injury could
result if bed is released and traps fingers or
other body parts.
To raise the manual lift bed, pull back on the latch release
handle immediately behind the driver seat (Ref Fig. 6 on
page 3). Raise the bed using the handle on the side of
the bed.
To lower the manual lift bed, grasp the bed handle and
lower the bed to the rest position. Be sure hands are
not trapped by the bed.
TAIL GATE OPERATION
To open the tail gate, lift tail gate straight up with a sharp
upward pull to lift out of the closed position and pivot out
for open position. To remove the tail gate, remove the
side cables from the loadbed and open tail gate until it is
straight down, move tail gate panel straight up to remove
from pins and remove from the load bed. Reassemble in
reverse order.
OPERATING THE VEHICLE
Improper use of the vehicle or
the lack of proper maintenance
may result in damage or decreased performance.
Read and understand the following warnings before
attempting to operate the vehicle.
To reduce the possi-
bility of severe inju-
ry or death resulting
Fig. 6 Manual Bed Latch
Ref Mbl 3
Front of Vehicle
Manual Load Bed Latch
Move Rearward to release

Textron EZGO Specifications

General

Brand	Textron
Model	EZGO
Category	Utility Vehicle
Language	English