OPERATION AND SERVICE INFORMATION
Page 19
Owner’s Manual and Service Guide
Read all of Manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
check plug and the fill plug. In the event that the lubricant
is to be replaced, a drain plug is provided at the bottom of
the differential housing.
AIR CLEANER INSPECTION AND REPLACE-
MENT
The air cleaner unit on the vehicle is a dry unit.
Do not use oil on the filter element or any part
of the unit.
The air cleaner is attached to the engine and may be
accessed by raising the seat. Inspect and replace air fil-
ter in accordance with the Periodic Service Schedule
(Ref. Fig. 13 on page 12).
The air cleaner element is accessible by unsnapping the
clips on the air canister and removing the cover and air
filter element (Ref Fig. 30 on page 19). Clean inside of
cover, canister and dust collector. Install the element and
cover the same way they were removed. Be sure the
positioning arrow on cover is pointing upward and all
clips are fastened securely.
Cleaning the Air Filter Element
Do not use compressed air to
clean the air filter; doing so will
damage the filter which may result in damage to the
engine.
If the element is in acceptable condition, loose dirt may
be removed by tapping the filter lightly. Do not use oil on
the filter element or any part of the unit. Install the ele-
ment in the same way it was removed, being sure that
the clips are fastened securely.
LUBRICATION
Do not use more than three (3)
pumps of grease in any grease
fitting at any one time. Excess grease may cause
grease seals to fail or grease migration into areas
that could damage components.
Putting more than three pumps of grease in a grease fit-
ting could damage grease seals and cause premature
bearing failure (Ref Fig. 31 on page 19).
SPARK PLUGS
Tool List Qty. Required
Spark plug socket, 13/16", 1/2" drive........................... 1
Ratchet, 1/2" drive....................................................... 1
Plug gauge, wire type.................................................. 1
Anti-seize compound................................................ AR
Torque wrench, 1/2" drive, ft. lbs. ................................ 1
Use care not to over-tighten the
plug. Over-tightening can cause
damage to the aluminum cylinder head threads.
Remove and inspect the spark plugs at intervals indi-
cated in the Periodic Service Schedule (Ref Fig. 13 on
page 12). All new spark plugs should be properly gapped
before installation (Ref Fig. 33 on page 21). Apply a light
Fig. 29 Add, Check and Drain Rear Axle Lubricant
Fig. 30 Canister Type Air Cleaner
Check Plug
Drain Plug
Ref Raf 2
Fill Plug
Dust
Collector
Air Cleaner
Cover
Air Cleaner
Canister
Air Filter
Element
Ref Air 2
Fig. 31 Lubrication Points
View From Underside Of Vehicle
Rack Ball Joint
Ref Lub 1
To Next Page
Loading...
Need help?
General
