Pagina 6 di 48
STDITR01ADP2090EV TECNOFRIGO TUSCANY srl
Marking unit
The marking unit with ID and EC is located on the left side under the electrical panel, as shown in the
figure below.
Safety symbols used
GENERIC DANGER
Observe all signs placed beside the pictogram. Failure to follow the warnings and instructions may result in
several injury or death to the machine operator, a bystander, or a person inspection or repairing the machine.
ELECTRIC DANGER
Observe all signs placed beside the pictogram. The symbol indicates components of machine or, in this
manual, actions that could generate a fulguration risk.
MOVING PARTS
This symbol identifies hazards associated with moving parts.
HOT SURFACES
This symbol identifies the presence of exposed hot surfaces that will cause serious burn injuries.
SHARP SURFACES
This symbol indicates that dangers may arise, for example, due to uneven surfaces, sharp edges, or the use of
operating materials and adjuvants.
ELECTRICALPANEL AUTHORISED PERSONNEL ONLY
Operation, maintenance and/or repair of the electrical panel must only be carry out by personnel trained and
qualified to work with electrical devices.
GROUNDING
This symbol identifies the grounding.
RECOVERABLE/RECYCLABLE MATERIAL
To Next Page
Loading...