66
3-7-13 Clutch
-Make sure that should not be oil strained,
cracked and unusual damaged from the
appearance.
-Replaced if the thickness of lining is less
than 1.5mm
3-7-14 Fitting
-Install the fixed driven face comp into the movable driven face comp.
Avoid to damage the lip of oil seal.
-Install two O-rings and apply grease to the groove of the cam then fit the guide pins.
-
pply a little grease inside of the spring sheet and manually push the spring sheet in lightly
and the install the spring and screw the central nut.
To Next Page
Loading...
