Theben KNX Series User Manual

The application programmes RAMSES 718 P/S
RAMSES 718 P / RAMSES 718 S 35
4.5.2 Measurement values
Designation
Values
Description
TEMPERATURE
Transmit temperature on change of
(internal sensor)
 Only valid for
temperature
measurement at the
internal sensor.
not due to a
change
Only send cyclically
(if enabled)
0.2 K
0.3 K
0.5 K
0.7 K
1 K
1.5 K
2 K
Send if the value has changed
by the selected amount since
the last transmission.
Send temperature cyclically
do not send
cyclically
every min,
every 2 min.
every 3 min.
…
every 45 min.
every 60 min.
How often should it be resent?
Temperature calibration
-64..+64
(x 0.1 K)
Correction value for
temperature measurement if
sent temperature deviates
from the actual ambient
temperature.
Example: Temperature = 20°C
sent temperature = 21°C
Correction value = 10
(d.h. 10 x 0.1°C)

Theben KNX Series Specifications

General

Communication Protocol	KNX
Ambient Temperature	-5°C to +45°C
Storage Temperature	-25°C to +70°C
Protection Class	IP20
Relative Humidity	5% to 95%, non-condensing
Operating Voltage	24 V DC (via KNX bus)