Theben KNX Series User Manual

The application programmes RAMSES 718 P/S
RAMSES 718 P / RAMSES 718 S 36
4.6 Room temperature controller RTC functional block
4.6.1 Setting
Designation
Values
Description
Control
Heating control only
Heating mode only
Heating and cooling
Additionally, a cooling system is
to be controlled.
Rotary control function
10
Base set point
The base set point is exclusively
set at the rotary control.
Manual offset
The set point can be adjusted via
the rotary control.
The base set point is received via
the base set point object.
Blocked
The rotary control has no
function.
The base set point is received via
the base set point object.
Manual offset works
in comfort, standby
and night mode,
in comfort and standby,
only for comfort
The set point offset:
Is only considered in the selected
mode and is ineffective in all
operation modes.
Manual offset at the end of night
mode
Do not change
Reset to 0 K
RAMSES 718 P: Only available
when the
function of the rotary control
is set
to base set point or blocked.
RAMSES 718 S: always available.
Use floor temperature limitation
(sensor at I4)
No
no floor temperature limitation.
10
Only RAMSES 718 P

Theben KNX Series Specifications

General

Communication Protocol	KNX
Ambient Temperature	-5°C to +45°C
Storage Temperature	-25°C to +70°C
Protection Class	IP20
Relative Humidity	5% to 95%, non-condensing
Operating Voltage	24 V DC (via KNX bus)