EasyManuals Logo

Thecus N8800 User Manual

Thecus N8800
153 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #29 background imageLoading...
Page #29 background image
29
Chapter 3: First Time Setup
Overview
Once the hardware is installed, physically connected to your network, and powered
on, you can configure the Thecus IP storage so that it is accessible to your network
users. There are two ways to set up your Thecus IP storage: using the Thecus
Setup Wizard or the LCD display. Follow the steps below for initial software setup.
Thecus Setup Wizard
The handy Thecus Setup Wizard makes configuring Thecus IP storage a snap. To
configure the Thecus IP storage using the Setup Wizard, perform the following
steps:
1. Insert the installation CD into your CD-ROM drive (the host PC must be
connected to the network).
2. The Setup Wizard should launch automatically. If not, please browse your
CD-ROM drive and double click on Setup.exe.
3. The Setup Wizard will start and automatically detect all Thecus storage
devices on your network. If none are found, please check your connection
and refer to Chapter 7: Troubleshooting for assistance.
4. Select the Thecus IP storage that you like to configure.
5. Login with the administrator account and password. The default account and
password are both “admin”.
NOTE
For MAC OS X users, double click on Thecus Setup Wizard .dmg file.

Table of Contents

Other manuals for Thecus N8800

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Thecus N8800 and is the answer not in the manual?

Thecus N8800 Specifications

General IconGeneral
BrandThecus
ModelN8800
CategoryNetwork Storage Server
LanguageEnglish

Related product manuals