System Network
Use the System Network menu to make network configuration settings as well as
service support settings.
WAN/LAN1
WAN/LAN1 Configuration
From the System Network menu, choose WAN/LAN1, and the WAN/LAN1
Configuration screen appears. This screen displays the network parameters of the
WAN/LAN1 connection. You may change any of these items and press Apply to
confirm your settings. See a description of each item in the following table:
WAN/LAN1 Configuration
Item Description
Host name Host name that identifies the Thecus IP storage on the network.
Domain name Specifies the domain name of Thecus IP storage.
WINS Server To set a server name for NetBIOS computer.
MAC Address MAC address of the network interface.
Jumbo Frame Support Enable or disable Jumbo Frame Support of the WAN/LAN1 interface on your
Thecus IP storage.
IP Sharing Mode When enabled, PCs connected to the LAN2 port will be able to access the
WAN/LAN1.
Link Aggregation Specifies whether WAN/LAN1 and LAN2 ports will be aggregated and act as
one port. There are 6 modes can be choose from:
Load Balance/Fail-over/Balance-XOR/802.3ad/Balance-TLB/Balance-ALB
Set IP Address by:
Static / Dynamic
You can choose a static IP or Dynamic IP, and input your network
configuration
IP IP address of the WAN/LAN1 interface.
Netmask Network mask, which is generally: 255.255.255.0
Gateway Default Gateway IP address.
DNS Server Domain Name Service (DNS) server IP address.
NOTE
The system must be rebooted before Thecus IP storage can function
normally after file system check complete.