8
For more information or to place an order visit www.thermaxaf.com
Steam Cleaning
Operational Instructions
1. With the power switch on, place the steam head about three feet in
front of you.
2. Depress the trigger to spray solution and slowly pull the steam head
toward you, while applying slight down pressure.
3. At the end of each backward stroke, release the trigger and push the
wand and the recovery head assembly back and forth over the same
area several times, using moderate pressure to remove as much solution
from the carpet as possible. Use the clear view recovery head as a visual
indicator to let you know when the carpet is clean and when as much
solution as possible has been removed from the carpet.
4. Overlap ½ and move on to the next section of carpet and repeat steps
1-3 until cleaning is complete.
5. When the spray from the solution hose gets weak and/or the pump
starts making a loud noise, it is an indication the solution tank is out of
solution. Turn off the machine and refill the solution tank as directed.
It is also recommended the recovery tank be emptied at the same time.
Replace both tanks and continue cleaning.
6. It is recommended that carpet be cleaned at least twice a year and more
often in high traffic areas.
7. To use the optional Hand Wand, simply attach it to the end of the vac
hose and connect the hose to the trigger valve. Fill tanks as described
above and proceed.
11
10
9
9. Snap trigger valve bracket onto handle as shown.
10. Connect the hose from the steam head into the spray
valve.
11. Connect the end of the trigger solution hose into the
solution tank fitting.
STEAM CLEANING
INSTRUCTIONS-SET UP CONTINUED
7
To Next Page
Loading...