5
For more information or to place an order call 1-888-764-3700
Vacuuming Instructions
1. Fill Water Filtration Recovery Tank to the fill line as noted on the label
and make sure the filter tube, filter chamber & baffle shut off assembly
are all in place.
2. Add Aqua Blue or fragrance to water as indicated on its label if desired.
3. Replace the recovery tank into the canister, making sure the 2 arrows
are pointing towards the front.
4. Close and latch the front lid.
5. Connect the vacuum hose: insert hose connector into front lid by
aligning the gold stripe on the hose end with the gold arrow on the hose
lock (located on the front lid). Hose lock must be on top as shown.
After inserting, twist the hose lock 1/4 turn clockwise to secure into
place.
6. To connect vacuum hose power cord into canister, plug into receptacle
cord outlet as shown. NOTE: is plug is polarized and will only go in
one way.
7. To connect the vacuum hose to the sliding wand, insert handle end into
the wand and gently twist until the button snaps into place.
8. To connect your motorized dry vacuum head (or the floor tool), insert
the sliding wand into the wand connector (located on the motorized
power nozzle) and push until button snaps into place.
9. Snap power cord from the motorized power nozzle into the two cord
guides located on the wand, leaving excess cord slack looped at the
motorized dry vacuum head.
10. Plug in the cord from the motorized dry vacuum head into the vac hose
handle as shown. NOTE: is plug is polarized and will only go in one
way.
3
5-6
7
8
9
10
1
To Next Page
Loading...