10
For more information or to place an order visit www.thermaxaf.com
Picking Up Liquids/Wet Pick-up
1. Be sure switch is off and canister is unplugged.
2. Before inserting the recovery tank, remove the filtration tube from the
filtration chamber inlet. (Filtration tube must be removed during wet
pick-up or steam cleaning function.)
3. Be sure that the secondary urethane foam filter (black) is in place in the
front lid.
4. Attach electrified vac hose (EVH) into hose lock (page 5 #5). NoTe:
DO NOT insert the male plug end of the EVH cord into the auxiliary
outlet when operating your AF2 as a wet pickup vacuum.
5. If attached, remove motorized vacuum head and power cord from
sliding wand and replace with the spray and recovery head, hard floor
tool, any on board tool, or optional squeegee.
6. Plug canister into proper wall outlet, turn power switch on and
commence operation.
Tips for Picking Up Liquids,
and Wet Pick-up:
• Never use the motorized dry vacuum head for wet pick-up.
• When using the canister to pick up water or other liquids, be sure the
filtration tube is removed from the filtration chamber.
• After vacuuming up a sticky or messy substance, flush clean the EVH
and wand by vacuuming clean, warm solution through the wand end as
described on page 9.
• Your AF2 system employs an automatic flotation ball shut-off system
to prevent overflow. When recovering solution during the wet pick-up
or hot water extraction functions, be sure that the flotation ball is in its
holder.
5
2
To Next Page
Loading...