The anchor bolt must be 20 mm or higher from the base surface.
1. Anchor bolt hole (X4)
Construct the molding according to the surrounding environment and climate zone, although always
reinforced with a steel mesh. Measurements in the picture above are recommendations of (minimal)
thickness and positioning of drain pipe.
4.5.1 Outdoor unit foundation
▪
The outdoor unit must be positioned outdoors on a stable base that can take the total weight of the unit.
▪
Secure all four mounting points on a stable base, for example one of the two the stands specifically designed for this product (sold
separately) or a cast foundation.
▪
If a cast foundation is made, make sure that the dimensions cover the horizontal plane area of the unit, with extra length with
regards for fastening the bolts (to make sure that there is no risk of the foundation to crack due to drilling too close to the edge).
Check with a spirit level that the heat pump is installed horizontally.
Installation Guide iTec XT
AWIXT01IG0102 Thermia AB
34
To Next Page
Loading...
Need help?
General