Need help?Do you have a question about the Thermia iTec XT and is the answer not in the manual?
General| Brand | Thermia |
|---|---|
| Model | iTec XT |
| Category | Measuring Instruments |
| Language | English |
Overview of available product documentation, including installation and user guides.
Explains warning symbols used in documents for danger, warning, and caution.
Describes symbols found on the heat pump's decals, varying by model.
Provides essential safety precautions for installation, service, and general operation of the heat pump.
Illustrates the heat pump's control display and navigation pad for system operation.
Guides through the initial commissioning process, including language and heat pump size selection.
Key information for initial startup, including language and size selection sequence.
Step-by-step instructions for selecting the display language via the Information Menu.
Instructions on how to set the heat pump size, including initial setup and later adjustments.
Outlines automatic and manual methods for determining the minimum flow required for system operation.
Details the process for automatically finding the minimum flow, applicable to models with optimum function.
Explains how to activate manual test modes for system checks and component testing.
Lists the various sub-menus available within the Information Menu for system monitoring.
Details the different operating modes like OFF, AUTO, COMPRESSOR, and AUX. HEATER.
Explains parameters related to heating system control, including curves and temperatures.
Lists the main categories available within the Service Menu for advanced configuration.
Covers parameters for setting hot water production start and stop temperatures.
Explains parameters for adjusting heating demand, start/stop thresholds, and heating time.
Details parameters for controlling the cooling function, including start/stop thresholds.
Guides on setting the desired operating mode for system startup and initial operation.
Describes the "COLD START" function, activated when the system is cold and the outdoor unit fails to start.
Explains how to adjust the heating system for optimal performance and comfort, focusing on heat curves.
Details how the CURVE parameter affects supply temperature based on outdoor temperature and how to adjust it.
Explains how the ROOM value shifts the entire heat curve to influence indoor temperature.
How to adjust specific points of the heat curve based on outdoor temperatures.
Function to automatically stop radiator heat production based on outdoor temperature.
Provides a comprehensive list of error codes displayed on the indoor unit and their potential causes from the outdoor unit.
Instructions for filling the installation protocol and informing the customer about the heat pump installation.
To Next Page
