Thermia iTec XT User Manual

6 Manual test
Caution The installation may only be commissioned if the heating system and
water heater have been filled and bled. Otherwise the circulation
pump can be damaged.
Caution Any alarms that may occur in connection with the installation must be
fault-traced.
6.1 Activate MANUAL TEST
N
Two people are recommended when doing the manual tests. One at
the control display and one at the outdoor unit.
MANUAL TEST has three options:
▪
Zero (0): deactivate manual test
▪
One (1): activate manual test. This option allows navigating only within the MANUAL TEST menu
▪
Two (2): activate manual test with the option of navigating out of the MANUAL TEST menu to check temperatures etc.
Set the heat pump in stand-by mode in the INFORMATION menu:
▪
Press
to enter the INFORMATION menu .
▪
Press to enter the OPERAT. menu .
▪
Press .
▪
Press
to move down to the (Off) symbol.
▪
Press to confirm. The asterisk * is now to the right of (Off) symbol.
▪
Press several times to exit the Information Menu.
▪
Enter the Service Menu by pressing and holding for at least 5 seconds.
▪
Press to navigate to the MANUAL TEST entry.
▪
Press
to enter the MANUAL TEST menu.
▪
Press to select option 2.
▪
Press once to exit.
N
The test cases in the table below are available in MANUAL TEST. Re-
quired test cases are described in the chapters that follows.
Test cases not described are optional.
Parameter Meaning
MANUAL TEST 0 = deactivate manual test
1 = activate manual test
2 = activate manual test with option of navigating from the SERVICE menu to check that the temperatures rise
for example.
OUTDOOR UNIT 0 = stop outdoor unit
1 = start outdoor unit
Commissioning iTec XT
AWIXT01CG0102 Thermia AB
24

Thermia iTec XT Specifications

General

Brand	Thermia
Model	iTec XT
Category	Measuring Instruments
Language	English