13 Installation protocol and customer info
Fill in the Installation protocol in the User Guide.
After installation and test operation, the customer must be informed about their new heat pump installation. In the User guide there is a
checklist regarding the information that the installer must give the customer.
The serial number must always be given for warranty matters. The seri-
al number is on the type plate, which is attached to the heat pump
and control unit. It can also be found in the display, in the SERVICE
menu, under INSTALLATION/VERSION.
Every serial number is unique to every heat pump. It is useful when in contact with customer support and maintenance matters. Image
example below.
VERSION
S N
DISPLAY
HUB
COMM.KIT
MAIN MICOM
INV. MICOM
EEPROM
Commissioning
iTec XT
AWIXT01CG0102 Thermia AB
58
To Next Page
Loading...
Need help?
General