Thermo King Spectrum - Page 25

TK 61651-18-OP-EN
25
AAuuttoo SSttaarrtt:: Should the unit stop due to a failure in the power supply,
whether during on-the-road or electric standby operation, it will start up
again as soon as the power supply is re-established.
SSoofftt SSttaarrtt:: All operation modes remain inactive for a few seconds after an
Auto Start.
AAccttiivvee DDiissppllaayy:: The HMI display is always active and backlit except when
the unit is disconnected (no power) or when the unit is connected but has
been manually switched off from the HMI (when there is no active alarm).
LLiitt KKeeyyppaadd:: The HMI keys are always lit except when the unit is
disconnected (no power) or when the unit is connected but has been
manually switched off from the HMI (when there is no active alarm). The On/
Off key is always lit except when the unit is disconnected (no power), and
thus indicates the presence of power in the unit.
TToottaall HHoouurrmmeetteerr:: Total number of hours the unit is in operation.
VVeehhiiccllee CCoommpprreessssoorr HHoouurrmmeetteerr:: Number of hours the unit has been
operating on-the-road.
EElleeccttrriicc SSttaannddbbyy CCoommpprreessssoorr HHoouurrmmeetteerr:: Number of hours the unit has
been operating in electric standby.
LLooww BBaatttteerryy VVoollttaaggee AAllaarrmm:: Disconnects the unit when the battery voltage
falls below 10.5V in 12VDC systems or below 21V in 24VDC systems.
BBuuzzzzeerr:: It is energised when the vehicle battery and the electric power
supply are connected at the same time. It is also energised if the doors are
opened while the refrigeration unit is running.
UUnniitt CCoonnttrrooll wwiitthhoouutt HHMMII:: The unit can also be operated by the Electronic
Control System without the HMI, under conditions selected by the HMI
before it is disconnected.
MMaannuuaall oorr AAuuttoommaattiicc DDeeffrroosstt:: It is possible to choose between manual or
automatic defrost.
MMaaiinntteennaannccee WWaarrnniinngg:: On-screen warning of the need to carry out
maintenance on the unit.
RReettuurrnn AAiirr TTeemmppeerraattuurree SSeennssoorr:: On-screen reading of the temperature in
the load compartment. In bi-temperature units, the temperature in both
compartments can be read on the same screen.
SSeettppooiinntt TTeemmppeerraattuurree RReeaaddiinngg:: On-Screen Setpoint Temperature
Reading. In bi-temperature units, the setpoint temperature of both
compartments can be read on the same screen.
EElleeccttrriicc PPoowweerr WWaarrnniinngg:: On-screen warning that the unit is connected to an
electric power supply.
UUnniitt DDeessccrriippttiioonn