46
D. STARTING THE BURNER:
1. Turn the main service switch to "OFF" position.
2. Set thermostat substantially above room temperature.
3. Open shut-off valves in oil supply line to burner.
4. Turn service switch to furnace "ON". If burner starts and runs, but stops again on lockout, it may be
necessary to bleed the lines or make burner combustion air adjustments. Contact a qualified service
person to adjust and start burner.
E. FILTER CLEANING AND LOCATION:
cWARNING: To avoid injury from moving parts, hot surfaces, or electrical
shock, shut off the power to the furnace before removing any furnace access
doors to service the air filters.
The air filters should be inspected each month and cleaned when dirty. Cleaning the air filters frequently
may reduce airborne contaminants from entering the furnace and depositing in the furnace, duct system
and home.
FILTERFILTER
RACK
RIGHT, BLOWER
ACCESS DOOR
PLENUM
REMOVE RIGHT BLOWER ACCESS
DOOR TO ACCESS FILTERS.
AFTER INSPECION AND/OR
CLEANING OF FILTERS RE-INSTALL
FILTERS AND ACCESS DOOR.
Fig 23: Filter Location for OD6
To Next Page
Loading...
