35
Password
Path: Setup/Password
The system has three levels of user passwords. Level 3 is the highest access level.
Most common functions can be assigned a specific password level. This allows the user to design their own password
structure. Typically, low level functions such as Select Product, etc. would be assigned a level 0 (no protection) or level 1
password protection. More critical functions such as sensitivity should be protected at a higher level.
NOTE: By default, password protection is Off which would mean no menus are protected. It is recommended
that custom passwords be established.
Default Passwords
Default passwords are as follows: Level 1 - AAAA Level 2 - BAAA Level 3 - CAAA
On
This option turns on the Password Protection and will require a level 3 access.
Off
This disables Password Protection and will require level 3 access.
Category
This lists the functions which can be assigned a password level by the user. Use the cursor arrows to select the feature you
wish to edit, press Plus or Minus to change the level (range 0-3) and press Accept to complete the edit.
The following features can be assigned passwords:
Select product Learn All QA test Special menus
Set Sensitivity Set application Reject setup Function Key
Clear rejects Alarm key Configure learn Erase Products
Edit Passwords
This allows the user to define custom passwords for each level and requires level 3 access. Select the level to be edited, press
the Plus and Minus keys and cursor arrows to define your new password. Only alphabetical characters can be chosen.
Log Out
Log Out tells the detector that you are leaving and therefore reinitiates Password Protection.
Using Passwords
When password protection is enabled any function which is protected will be visible to any user but cannot be edited unless the
password to the correct level is entered. The unit will request the password at the initiation of an edit attempt. Once you have
entered the password you may continue with the edit function. When you have completed the changes required, if you wish to
reinitiate password protection you must log out. This can be done from the top display, select Log Out.
Forgot Your Password?
If the incorrect password is entered when requested, by pressing Forgot the Password, seed numbers will be displayed for the
three password levels. By contacting Goring Kerr with these seed numbers, we can decipher your password. Be prepared to
produce evidence of your authority.
To Next Page
Loading...
