1-2 MaxQ 2000 Shaker Thermo Scientific
Section 1
Safety Information
8. Use equipment only for its intended purpose. Use only the accessories
and attachments that are shipped with the equipment, or are specified
for it. Substituting other attachments or accessories can produce
hazards or make the unit inoperative.
9. Perform regular maintenance service as specified in this manual and
keep unit in good repair. Do not operate with known defects.
10. User is to determine optimum load/speed combinations to ensure that
shaker operates safely with a balanced load. Normal operation can
include the requirements of the type of studies to be performed, i.e.
aeration, solubility, mixing, etc. The vessels should be securely
clamped before turning on shaker and contain a stopper whenever
possible to prevent hazardous substances from being thrown out
during shaking action. Shaking action should be set to begin at a slow
speed and gradually increased to desired speed. The following stability
chart indicates if additional bracing is required.
10 lbs 20 lbs 30 lbs 40 lbs 50 lbs
100 rpm No No No No No
200 rpm No No No No No
300 rpm No No No No No
325 rpm No No No No No
350 rpm No No No No No
400 rpm No No No No No
450 rpm No No No Yes Yes
475 rpm No No No Yes Yes
500 rpm No No No Yes Yes
To Next Page
Loading...
