__________________________________________________________________________
Installation option 1 – Self-assembled cold room with plastic cover
1.
Adapt hole in wall 440x740mm as illustrated. Distance from ceiling to top of light aperture minimum
310 mm. Minimum air flow 200 cm²
2.
The plug for the mains cable is installed outside the cold room. If it protrudes beyond the plastic cover,
the mains cable must be fastened so that it cannot fall down into the condenser fan.
3.
Build the cold room in accordance with prevailing laws and regulations. See the
Thermocold website www.thermocold.no
for tips and advice for construction.
4.
Fix the insulating strips around the opening on the inside of the cold room side using staples or tape.
5.
Lift the unit into position from the cooling room side and fasten with screws in each corner.
The gasket should be against the wall, not the cooling unit.
6.
Adjust the air barrier that separates intake and exhaust. Make sure that the air barrier protrudes
approx. 10 mm outside the wall, so that it is placed in contact with the recess in the plastic cover, see
detail marked 3.
7.
Attach the air seal with one screw in the truss on each side.
8.
Screw the plastic cover to the wall and not to the unit. Make sure the recess in the plastic cover is
correctly placed against the air barrier. The entire air slot above and below the air barrier behind the
plastic cover must be open for free air flow.
9.
Plug in the mains lead and ensure that the unit starts up.
Structure.
Seen from the
outside of the
Insulation min.100 mm
and vapour barrier
.
Seen from the
outside of the cold
Plastic cover.
Fully installed
from the
outside of the
Cross-section.
See detail 3
To Next Page
Loading...