Why are the pH readings inaccurate on my ThermoFisher Scientific thermo scientific imPULSE S.U.M. Laboratory Equipment?
Inaccurate pH readings can occur due to: * pH readings will always be displayed, even without a sensor or cable connected. * pH calibration issue.
Why the motor will not turn on ThermoFisher Scientific Laboratory Equipment?
If the motor won't turn on, the possible causes are: * Motor communication cable issue. * Power to AC motor module issue. * Motor power cord issue.
Why is the mass reading not displaying on my ThermoFisher Scientific Laboratory Equipment?
If the mass reading is not displaying, the issue might be: * A load cell/load cell cable problem. * A load cell summing box problem.
What to do if my ThermoFisher Scientific Laboratory Equipment Touchscreen Console is stuck on the boot-up screen?
If your Touchscreen Console is stuck on the boot-up screen, it could be due to: * A read failure requiring a reboot (if intermittent). * Corrupted firmware or hardware failure.
Why are the mass readings inaccurate on my ThermoFisher Scientific thermo scientific imPULSE S.U.M.?
Inaccurate mass readings could be due to: * Incorrect vessel size. * Inaccurate load cell calibration.
What to do if the Touchscreen Console of ThermoFisher Scientific thermo scientific imPULSE S.U.M. will not turn on?
If the Touchscreen Console won't turn on, the possible causes are: * A faulty power plug or outlet. * The fuse (circuit breaker) is shut off.
What to do if the motor speed display is incorrect on ThermoFisher Scientific thermo scientific imPULSE S.U.M. Laboratory Equipment?
If the motor speed display is incorrect, try the following: * Reset to factory settings if the display is not set correctly. * Check the circuit breaker to see if it has been tripped. If the breaker was tripped, reset the circuit breaker.
What to do if the displayed weight on my ThermoFisher Scientific Laboratory Equipment is incorrect?
If the displayed weight is incorrect, consider the following: * Remove the shipping block if it is still in place. * Check for broken wires; if found, replace the load cell(s). * Torque the mounting bolts if they are loose. * Check the circuit breaker to see if it has been tripped. If the breaker was tripped, reset it.
General| Brand | ThermoFisher Scientific |
|---|---|
| Model | thermo scientific imPULSE S.U.M. |
| Category | Laboratory Equipment |
| Language | English |
Provides a general overview of the imPULSE S.U.M. system and its key features.
Details the features and components of the imPULSE mixer's motor drive assembly.
Describes the characteristics and hardware components of the Touchscreen Console.
Covers essential steps for preparing the installation site, including electrical connections.
Provides detailed instructions for the physical installation and setup of the imPULSE S.U.M.
Guide to customizing the Home screen by adding and configuring modules.
Details the process of setting up and using an Administrator profile for enhanced control.
Explains the function and requirements of each available module on the Touchscreen Console.
Step-by-step guide for calibrating the system's pumps for accurate fluid delivery.
Instructions for calibrating the pH sensor to ensure accurate pH measurements.
Procedure for calibrating the conductivity sensor for accurate readings.
Detailed steps and guidelines for filling the imPULSE S.U.M. with liquid.
Instructions on how to start and control the agitation process for effective mixing.
Overview of how to monitor and control various system functions during operation.
To Next Page