Thinkware Q1000 - Installing the Rear Camera (Optional); Selecting an Installation Location

Installing the product
15
1/8
1/4
Connect the product to THINKWARE DASH CAM LINK on
your smartphone and adjust the camera angle so that the
hood of the vehicle covers 1/4 - 1/8 of the screen while
viewing the live view screen, as shown in the image to
the left.
For more information about connecting and using the
THINKWARE DASH CAM LINK, refer to "4. Using the
mobile viewer" on page 24.
2.2󳒀 Installing the rear camera (optional)
Refer to the following instructions to properly install the rear camera.
2.2.1󳒀 Selecting an installation location
Select a location on the rear windshield where there
is no defrost grid wire and the camera can record
the entire rear view.
•󳒀 For vehicles with a sunshade attached to the rear windshield, you must select a location where using the
sunshade will not interfere with camera operation.
•󳒀 The adhesive part of the rear camera should not touch the defrost grid.